XSAEW Potentiometer Digital Display Instrument
Paired with resistor scale and potentiometer. (replaces original XSAE)
Single 6-digit LED display, display range is -99999~99999
According to the characteristics of the resistor scale (potentiometer), the input circuit has been optimized
The display and measurement stability are improved, and the ability to resist electromagnetic interference and serial mode interference is improved.
0.05 level accuracy, measurement and control speed can be set 5-200 times per second, display range -99999~99999
Panel buttons and switch input setting function
10-point polyline correction function
Optional 1~4 points alarm output. It includes six basic alarm modes: upper limit of measured value, lower limit of measured value, upper limit of deviation, lower limit of deviation, upper limit of absolute value of deviation, lower limit of absolute value of deviation, four standby alarm modes of upper and lower standby limits, upper and lower standby deviation limits, and one input fault
alarm mode. .
(Standby alarm mode: means that the instrument will not alarm even if it is in the alarm area when the power is on. When the measured value enters the non-alarm area, the standby condition will be established, and then the alarm will be normal.)
Content | Code description |
XSAEW- | 0.05 level measurement accuracy; Single display |
Dimension | AH | 160×80×125 Hole Size:152×76 |
CH | 96×48×82 Hole Size：92×45 |
Panel specifications | | 6 digit LED, display range-99999 to 99999 |
Signal input(Other input singals instructions when ordering) | W | potentiometer（500Ω～10kΩ） |
Contact input (optional) | K1 | 1 point external switch input for zeroing.(When AH and CH select K, communication and transmission can only choose one option; E size does not support K option) |
Alarm（option）(250V AC/3A,resistive load) | AH | T1～T4 | 1~4 point relay output, are normally open and closed double contacts |
CH | T1～T2 | 1~2 point relay output, are normally open and closed double contacts |
T3 | 3 point relay output is a single open contact. |
Transmitting (optional) (resolution: 1/3000; load capacity: 600Ω） | A1 | Current output（4-20）mA、（0-10）mA、（0-20）mA |
A2 | Voltage output（1-5）V、（0-5）V |
A3 | Voltage output（0-10）V |
Communication (optional) (Photoelectric isolation) | MS1 | The RS232 interface can select the TCASCII or Modbus-RTU through the software settings |
MS2 | The RS485 interface can select the TCASCII or Modbus-RTU through the software settings |
Power Specifications | V0 | 100-240V AC 50/60 Hz |
V1 | 10-24VAC 50/60Hz；10-24VDC |
